Clutch for Lombardini, Benassi, Pasquali and Fort motor tillers
Cone clutch for tillers equipped with Lombardini engines , designed for power transmission between the engine and the implements. A critical component in the tiller's transmission system: wear or breakage causes total loss of traction and machine shutdown.
Technical specifications
- Type: Tapered shaft clutch
- Cone: 23
- Total length: 104 mm
- Diameter: 66 mm
- Number of stretch marks: 9
- Original version: Original Lombardini Kohler replacement part
- Alternative version: LM-Parts replacement (for equipment that already incorporates components of this brand)
Important: Before ordering, please verify that the dimensions of the clutch being replaced exactly match the specifications. The cone, length, and diameter must be identical to ensure proper fit.
Compatibility with tillers and cultivators
This clutch is compatible with tillers and cultivators of the following brands equipped with a Lombardini engine :
- Benassi — models with Lombardini LDA engine and compatible series
- Pasquali — agricultural range tillers and cultivators
- Fort — compatible cone transmission equipment
- Lombardini — machinery owned by the brand
If you have any doubts about compatibility with your specific model, please tell us the brand, model and year of manufacture of the rototiller and we will confirm it before you place your order.
Symptoms of clutch wear in a rototiller
The most common symptoms indicating that the Lombardini tiller clutch needs replacing are:
- Progressive or total loss of traction when engaging gear
- Clutch slippage under load on hard ground
- Metallic noise or abnormal vibration when connecting the transmission
- Difficulty disengaging the clutch or clutch that does not fully release
- Visible wear on the shaft splines or on the conical surface
Installation and technical recommendations
For correct installation of the Lombardini rotary tiller clutch :
- Check the condition of the engine output shaft before installing the new clutch — a worn shaft can damage the new component
- Clean and degrease the shaft cone before assembly
- Check the return spring tension after installation
- Do not force the coupling — if it does not go in easily, check the cone measurements.
- Consult the engine parts manual for the tightening torque of the fixing bolt
Frequently asked questions about the Lombardini rototiller clutch
How do I know if my rototiller has a 23mm cone?
The taper number refers to the angle and diameter of the engine's tapered output shaft. You can measure it directly on the shaft with calipers or consult your Lombardini engine's workshop manual. You can also send us a photo of the shaft, and we'll confirm the measurement.
What is the difference between the original replacement part and LM-Parts ?
The original replacement part is manufactured by Lombardini Kohler according to their production standards. The LM-Parts alternative is a replacement part with the same dimensions and equivalent materials. If your tiller already incorporates other LM-Parts components, the alternative is the correct choice to maintain system consistency.
Can I fit this clutch to a BCS rototiller?
It depends on the model and the engine installed. Some BCS tillers have a Lombardini engine compatible with this clutch. Please tell us your BCS model and the engine it has, and we will confirm compatibility.
Can't find the clutch for your model? Check out the clutches for Lombardini BCS, Benassi, and Bertolini tillers , or contact us with the measurements of your current clutch and we'll locate the exact replacement for you.
